ADDITIONAL SERVICES

Cutting to fix lengths

In case several short lengths of one size are ordered, EEW will always make use of the price worthy combi-length production of up to 13.2 metres in length and subsequently cut into pieces

Point-to-Point Construction

Our clients are correct in expecting always best service. Depending on the project, we produce structural pipe components
according to our point to point construction service. This service contains detail engineering from the AFC drawing until
the delivery of ready to assembly pipe components.

End machining

EEW performs all shapes of end bevels / tapers on several end-facing machines.

CNC oxy-cutting

EEW performs CNC cuts of all kinds of holes into the pipe, including weld seam preparation according to drawing.

Circumferential welds

Circumferential welds are our speciality for which we run a separate production which is equipped with special machines.

Limited tolerances

Pipes of limited tolerances have always been part of EEW's production range. Modern calibration presses are installed.
This represents a considerable improvement of our capacity and thus the output of pipes for the machine construction.

Welded spools

Welded spools will be pre-fabricated according to client drawings.

Heat treatment

All pipes and constructions are heat treated according to requirements in several furnaces of size up to 5,500 mm width, 4,700 mm height and 13,200 mm length.
Furthermore pipes can be inductively heat treated up to 1,600 mm O.D. and air/water cooled, if required.

Surface treatment

All kinds of surface treatment can be supplied, beginning with shotblasting, a simple temporary rust protection up to special multilayer coatings and plastic coatings.